RADIAL DISTRIBUTION NETWORK MODELING AND ANALYSIS CONSIDERING POWER FLOW AND RECONFIGURATION (A CASE STUDY OF AZARE DISTRIBUTION NETWORK)

0
703

RADIAL DISTRIBUTION NETWORK MODELING AND ANALYSIS CONSIDERING POWER FLOW AND RECONFIGURATION (A CASE STUDY OF AZARE DISTRIBUTION NETWORK) ( ELECTRICAL AND ELECTRONIC PROJECT TOPIC)

 

ABSTRACT

The complexity and large number of computations involved in power flow and reconfiguration analysis of large distribution networks necessitates the need for the improvement of power flow and reconfiguration techniques. In this research work, a GPS based method is used in modeling Azare distribution network and in selecting the most appropriate positions of Tie branches (required for network reconfiguration). Radial distribution network power flow and reconfiguration algorithms are developed based on improved Backward-Forward Sweep (BFS) and All Spanning Trees of Undirected Network Graph (ASTUNG) techniques respectively.MATLAB GUI based simulators are also developed for power flow and reconfiguration analysis. The developed simulators are used in simulating power flow and reconfiguration on the Azare distribution network. A voltage profile improvement of 64.11% and a total real power loss reduction of 54.4% are achieved in the optimum configuration compared to the original configuration. Finally, the effectiveness of the developed power flow simulator is also demonstrated by testing it using the Standard IEEE 30 and 33 bus networks and comparing the results with those obtained in other similar literatures; while the effectiveness of the reconfiguration simulator isdemonstrated using the standard IEEE 33 bus network. The developed reconfiguration simulator was able to improve the voltage profile of the standard 33 buses IEEE radial network by 65.7% and reduce its total real power loss by 56.17%; and when compared with other similar literatures, an improvement of 14.23% is made in voltage profile while a reduction of 0.31% is achieved in power loss. All computations and simulations were performed using MATLAB V.7.0 Software.

CHAPTER ONE

GENERAL INTRODUCTION

1.3 General Background

Distribution system is the largest portion of the electrical power system. It can be defined as the part of a power system that distributes power to various customers in ready-to-use form at their place of consumption .(Ramesh et al, 2009). Optimal planning and design of the distribution systems involves network reconfiguration for distribution loss minimization, load balancing under normal operating conditions and fast service restoration to minimize the zones without power under failure conditions (Muhtazaruddin et al., 2014). Most of the distribution networks are configured radially which simplifies over-current protection of the feeders (Muhtazaruddin et al., 2014). The manual or automatic switching operations are performed to vary the configurations. As the operating conditions change, the purposes of network reconfiguration are (Muhtazaruddin et al., 2014):

(i) To minimize the system power loss;

(ii) To balance the loads in the network.

(iii) To improve the voltage profile.

DOWNLOAD COMPLETE PROJECT MATERIAL

RADIAL DISTRIBUTION NETWORK MODELING AND ANALYSIS CONSIDERING POWER FLOW AND RECONFIGURATION (A CASE STUDY OF AZARE DISTRIBUTION NETWORK) ( ELECTRICAL AND ELECTRONIC PROJECT TOPIC)

Leave a Reply