CONSTRUCTION AND DESIGN OF 1.5KVA INVERTER
DEDICATION
I dedicate this project work to Almighty God, the source of all knowledge, wisdom and understanding, for being there for me throughout the period of my study and to my lovely parents, Mr. and Mrs. (write name here) for their parental care, who has always been my inspiration.
TABLE OF CONTENT
CHAPTER ONE===================================1
INTRODUCTION==================================1
1.1Â Â Overview====================================== 1-2
1.2. Basics of the project==============================2-4
1.3 Block diagram and its description==================== 4
CHAPTER TWO===================================6
Concept of the Project=============================== 6
2.1 1Literature ==================================== 6-7
2.2 Review========================================7-9
2.3 Theory========================================9-10
CHAPTER THREE=================================11
Design Requirements and Explanation=================== 11
3.1 Components used and its details===================== 11-12
The Resistor====================================== 12-13
The Potentiometers=================================14-19
Capacitor========================================16-20
LEDs===========================================21-22
Zener diode======================================22-23
CD 4047=======================================24-25
Transformer====================================26-27
3.2 Circuit diagram==============================27-30
Drawbacks of the circuit==========================30
3.4 Problem statement============================30-33
CHAPTER FOUR CONCLUSION===================34
4.1 Conclusion==================================34-35
4.2 Accomplishments=============================35
4.3 Uncertainties================================35-36
Abbreviations==================================36-37
CHAPTER ONE
INTRODUCTION
1.1 Overview:
The primary objective of the contents of this file is to provide adequate breadth and depth for basics in electronic components at the undergraduate level. The document contains the procedure right from drawing the circuit diagram on the page to its implementation on the Printed Circuit Board. It includes the information of the basic components of electronics like the capacitor, resistor, diodes and also a little bit information of the integrated circuit CD4047. It has the information about the software used that is the Proteus software which is very useful in designing the very important part of the project i.e., the PCB layout without which one cannot imagine to implement the circuit in its materialistic form. The Proteus schematic capture module also provides a very high degree of control over the drawing appearance, in terms of line widths, fill styles. Fonts, etc. although the designing of the circuit on proteus software is a tedious job. it is just very much useful for the operator to get the signal that the circuit is working on software basis. But it does not mean that the circuit will also run in the materialistic form.
