CONSTRUCTION OF A DISTILLATION COLUMN WITH REFLEX DIVIDER AND CONDENSER.
ABSTRACT
In this project, distillation is made up of a column, condenser and reflux divider. An overview of the dimensions of some of the major parts is:
Height of the column = 450mm
Diameter of the column = 100mm
Length of the condenser = 150mm
Diameter of the condenser =90mm
Diameter of the pipe = 22mm
Length of the reflux divider = 150mm
Height of the reflux divider = 150mm
Width of the reflux divider = 100mm
TABLE OF CONTENT
CHAPTER ONE
1.1Â Â Â Â Â Â Â Â Â Introduction
CHAPTER TWO
2.0Â Â Â Â Â Â Â Â Â Literature review
2.1Â Â Â Â Â Â Distillation process
2.1.1Â Â Binary Distillation
2.1.2Â Â Â Â Â Multi Component Distillation
2.2Â Â Â Â Â Â Â Â Â Two principle method of distillation
2.2.1Â Â Â Â Â Continuous Distillation with reflux (rectification)
2.2.2Â Â Â Â Â Batch Distillation with rectification
2.3Â Â Â Â Â Â Â Â Â Column
2.3.1Â Â Â Â Â Condenser
2.3.2Â Â Â Â Â Reflux divider
CHAPTER THREE
3.1Â Â Â Â Â Â Â Â Â Properties and Selection of Material
3.1.1Â Â Â Â Â Effect of temperature on the Mechanical Properties
3.1.2Â Â Â Â Â Corrosion and erosion resistance
3.1.3Â Â Â Â Â Economic Consideration (Cost)
3.1.4Â Â Â Â Â Contamination
CHAPTER FOUR
4.1Â Â Â Â Â Â Â Â Â Construction procedure
CHAPTER FIVE
5.0Â Â Â Â Â Â Â Â Â Costing
CHAPTER SIX
Discussion
Conclusion
Recommendation
CHAPTER SEVEN
APPENDIX
REFERENCES
CHAPTER ONE
INTRODUCTION
Distillers is a process of vapourizing a liquid mixer by the application of heat in which two distinct or different phases and created namely the vapour phase and the liquid phase and the liquid phase and it is expected that the more volatile component will be found more the gaseous phase while the less volatile will be found in the liquid phase. This separation is achieved because there is usually a difference in the composition between a liquid mixer and the vapour in equilibrium above it. Hence, by careful management of repeated vaporization and condensation from a liquid mixer, pure component fractions can be achieved.
Distillation is thus based on the difference in equilibrium composition between vapour and liquid phases of a mixer. The characteristics and reason for the equilibrium should be understood. The ways in which these equilibrium data can be recorded for later use in distillation design and possible ways of predicting such data are natural pre-requisites for any course on distillation design.
An example of distillation with condenser and reflux divide is applied in the separation of alcohol from water. By the application of heat we can practically vaporize the solution, there by create a gas phase consisting of nothing but alcohol and water since the gas will be richer in alcohol than the residual liquid, a contain amount of separation have taken place. By repeater vaporization and condensations it is then possible to make as complete a separation as may be desired, recovering both components of the mixture in as pure a state as we wish.
